Soudaseal Mirror

Soudaseal Mirror is a high quality, neutral, 1-component mirror adhesive based on MSPolymer.

Soudaseal Mirror is a high strength mirror adhesive, compatible with all acetone resistant mirrors.
- Fast curing
- Primerless adhesion even on damp surfaces, due to Soudaseal HT’s unique adhesion promoters.
- Stays elastic after curing and very sustainable
- No odour and does not contain solvents
- Does not contain isocyanates and no silicones
- No risk for staining on porous substrates (migration of plasticizer).
- Colourfast.
- Bonding of all kinds of mirrors with an acetone safe back
- Sealing of joints in mirror walls
- Bonding of mirrors even on damp surfaces
- Water resistant bonding
Directions for use
Substrates: all usual building substrates, treated wood, PVC, plastics
Nature: clean, dry, free of dust and grease.
Surface preparation: Porous surfaces in water loaded applications should be primed with Primer 150. All smooth surfaces can be treated
with Surface Activator.

Soudaseal Mirror has excellent adhesion on most substrates. Soudaseal Mirror can also be used on natural stone. We recommend a preliminary adhesion test on every surface.

There is no adhesion on PE, PP, PTFE (Teflon®), silicones and bituminous substrates.

Min. width for bonding: 10 mm
Min. thickness: 3 mm
Recommendation: use double-sided adhesive tape as a spacer between the wall and the freely suspended mirror
- Due to the wide variety of types of mirrors, we strongly recommend preliminary compatibility tests.
- Due to the low initial tack, the mirrors need to be supported during the curing process until the adhesive has fully cured. The time required depends on the weight/size of the mirror, temperature, relative humidity and the amount of product used.
- In order to avoid possible problems due to condensation, the mirror manufacturers as well as Soudal recommend sufficient ventilation at the back of the mirror. As a guideline, an opening of 3-4mm should be left between the surface and the mirror. This can be assured by the use of double sided mirror tape.
- We recommend this minimal ventilation opening of 3-4mm to ensure correct curing of the adhesive/sealant. Full surface bonding is at own risk of the applicator.
- For larger mirrors always use the adhesive in combination with a very good and qualitative double-sided adhesive mirror tape.
- Mirrors that are fitted with a safety film at the back to avoid shattering must be pretreated with an adhesion promoter. The use of Soudal Surface Activator will ensure the best bonding performance on this type of safety film. Without the use of Soudal Surface Activator the adhesive bond might be insufficient with the risk of an unsafe