MS-30PLUS
Add to quick accessHybrid polymer timber flooring adhesive
MS-30 Plus cures by means of a chemical reaction within the adhesive. Once fully cured
(approx. 24 hrs. at 21°C and 50% RH) an elastic and non-shrinkable adhesive layer is formed, which is resistant to moisture and heat. The adhesive has excellent adhesion to most common substrates used in the construction industry.
MS-30 Plus contains no water or solvents, minimizing the risk of deforming the parquet to a minimum.
Featured properties
- Hybrid polymer parquet adhesive
- Ready to use, single component
- EC-1 PLUS - very low emission
- Solvent and isocyanates free
- Easy to apply
- Forms stable peaks when applied with a notched trowel
- Rapid cure and build up of final bond strength
- Suitable for underfloor heating
Assets
TDS Soudal, MS-30PLUS, English
Applications
- Suitable for bonding all types of wooden floors; solid, stab, pre-finished, on-end parquet, wood plank, wood-block and laminates. Ideal for use on porous and non-porous substrates such as mosaic, anhydrite, concrete, screeds, wood, chipboard and OSB Board, including floors with underfloor heating.
Example of Applications
Instructions
- Apply the adhesive to the surface by means of notched SOUDAL trowel N°11. For parquet sizes smaller than 60mm wide and 300mm long notched SOUDAL trowel N°3 is recommended. Do not apply more to the surface than can be covered with parquet within 30 minutes. Slide the parquet onto the adhesive layer and tap into place or tamp down with a rubber hammer. A minimum of 80% contact coverage is required to ensure a perfect adhesion. Loading the parquet with weights will improve the final bond strength. Wait at least 16hrs before sanding and finishing the parquet.
